Nissan 350Z & Infiniti G35 Aluminum Under Tray

Raw Aluminum Finish

Protecting your engine is very important, and the OEM splash shield doesn't do much.  This aluminum engine shield is a direct fit for the Nissan 350Z and Infiniti G35.  Not only will it protect better than the plastic splash guard, it will strengthen your bumper and make your vehicle easier to work on.  Imagine not having to take the entire under tray off each time you change your oil!  The built in oil trap door on this aluminum splash shield will make changing the oil a quick and clean process for your G35 or 350Z.  Sleek, stylish, keeping the engine clean and offering much better protection, all while weighing only a single pound over the stock plastic under tray.  Don't hesitate to put this on your car, as it will be one of the best value purchases you can make for your G or Z.

Protect your VQ with only the best.  Made from high quality aluminum, all holes are laser cut to direct fit in the stock location.  This version is designed to accomodate larger oil pans, spacers, and some lower front tie braces.  Installation is quick and requires little working knowledge.  Most people can do it on there own with a floor jack, jack stands, and a 10mm wrench in about 10 minutes!  

Will fit all OEM bumpers except the Nismo 350Z/NismoV3.  This will also mount up to MOST aftermarket bumpers.  However, since there are so many aftermarket options, you can verify by taking a couple measurements.  The OEM bumper sits roughly 3/4" lower than the radiator support.  Also the distance between the holes in the radiator and the center mounting holes in the bumper is roughly 8".  If you measure these to dimensions and they are close to this, you should have no issues with fitment.  HOWEVER, if yours does not, such as the Kuruma Z bumper for the 350Z,  you will need to verify which bumper you have or else discuss with us about making a custom front panel to fit your bumper correctly.

FITS:
2003-2009 350Z (not NISMO V3)
2003-2007 G35 Coupe
2003-2006 G35 Sedan (RWD only) 

• MADE OF .063 ALUMINUM - only slightly heavier than stock (by ~ 1 lb) but hard aluminum resistant to denting and splitting
• LASER CUT - Precise cuts to fit stock mounting points
• CLEARANCE - Clearance as good as OEM or better, but stronger which improves airflow FITS 1" oil pan spacer
• RIGIDITY - Offers better protection while strengthening bumper support for better stability at high speeds
• 3 PIECE DESIGN - Won't bend the whole thing if you hit a curb, and can replace only the front piece. Easier to work on your engine.
• OIL DOOR - The OEM shroud offers little access to the filter. This built in oil door is accessible by removing 2 simple bolts.
• VENTED DESIGN - Helps to aid with air flow and heat removal